Talk About the Latest in Home Automation/Home Electronics -
Home Automation Forum

Smarthome Forum
Insteon Home Automation
Login or Register
 
Home | Profile | Register | Active Topics | Search | FAQ | Smarthome | Security and Privacy | Do Not Sell My Info
 All Forums
 General Discussion
 Thermostats & HVAC Control
 Control Frequency of Furnace Starts
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Fred Burr
Starting Member

USA
1 Posts

Posted - 03/15/2019 :  7:55:30 PM  Show Profile  Reply with Quote
I am installing an Insteon 2441TH thermostat, to control a forced air natural gas fired furnace, with an associated air conditioner and cold deck.

Is there a way that I can get this thermostat, or another Insteon compatible thermostat, to adjust the frequency with which the furnace comes on, e.g., the delay between when the furnace turns off, and when it turns on again? This could be done with controller deadband, or with a time delay between stop and start, internal to the thermostat firmware. The thermostat I am replacing is overly sensitive, it will kick the furnace on, run for a few minutes, then 10 minutes or less after it has turned off, turn on again, during these Montana winters....

Thanks for any thoughts.

You cannot improve something unless you can measure it.
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Smarthome Forum © 2000-2020 Smartlabs, Inc Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.07